I am trying how to allow Windows 10 smb client (pc1) login to Windows 7 smb server (pc2). It says “Password Invalid” even its valid, same issue on new account.
If i try to access Windows 10 smb server(pc1) from Windows 7 smb client (pc2), the issue doesnt happen. Which parameters on Windows 10/11 i must check to solve this problems? (both machines are configured as client/server).
I dont know if this issue happens with Windows Server 2012R2 smb servers login from Windows 10/11 smb clients.
pc1 to pc2 login = Password Invalid even its valid pc2 to pc1 login = Login Sucessfull
I recommend testing this out using lower limits and smaller file sizes. I also recommend testing by sending to a non-Outlook domain.
I went through this today, and partly used this site as a resource. I also realized through testing (by sending to a Gmail account, with a receiving limit of 25MB) that the response was being generated by Outlook.
I recommend lower limits because OWA has limitations on sizes documented by Microsoft and referenced in another comment.
As an example, if you’re sending a ~42 MB file, and using OWA Outlook, then the limit needs to be more like 60MB (not that it’s the correct percentage, only that I know making a similar change resulted in success).
My testing recommendation would be to send a file to a Gmail account that you know is less than the Outlook limitation but greater than the Gmail limitation. If you still get the 35MB response, then you know it’s Outlook and not Gmail.
“OWA, however, restricts the size of the message you can send to 25 percent less than the configured allowed maximum send size.”
I don’t know if the above is relevant (especially considering that 110 MB is right at the edge of 25% of 150 MB), but I tested this out myself and had to increase my limit because the file I was testing with was within that margin.
The “remote server” part of the response if probably throwing you off, but the important part to focus on is that it’s indicating that the message is too large for the sender and not the recipient. Typically, if the recipient rejects the message, you’ll get: “Your message wasn’t delivered because the recipient’s email provider rejected it.”
I need your help regarding the code with TFTP as you were added TFTP commands in last . Can you share the code with TFTP after editing i want to take configuration backup in config file format like TFTP take configuration backup and put this backup on TFTP directory. Appreciate if you can help me.